45
How to program printing information
1) To go to PROGRAM mode, press 1 by using numeric keys and MODE key.
2) Press v key five times.
3) The WEIGHT display shows “SEt”.
4) Press PRT/* key, “SEt EntEr”.
5) Press 6 key and PRT/* key.
6) The display shows “PmodE EntEr 0”.
pMode 0 : No change with unit price
pMode 1 : Temporary change with unit price
pMode 2 : Permanent change with unit price
7) Look at the table below and type number that you want.
8) Press PRT/* key. The display shows “PEEL EntEr 1”.
9) Look at the table below and type number that you want.
<PEEL sensor ON/OFF>
0 : Peel sensor OFF
1 : Peel sensor ON
10) Press PRT/* key. The display shows “SEt”.
11) If you wish to finish PROGRAM mode, press C key
To Next Page
Loading...
