Chapter 12: Program Application 224Chapter 12: Program Application 224
VWin Misc - Setup(3)
Function: Used as a SetSmryTable command
argument to specify an option. See SetSmryTable.
W
Wait Ctrl - Control
Syntax: Wait[<expression>]
Function: Pauses program execution, and then
restarts it after the number of seconds specified by
the expression passes.
Description:
• If you do not specify any expression, program
execution is paused until you tap the screen, or
press a key.
• The maximum valid specification for <expression>
is 360 seconds (six minutes). Specifying a value
greater than 360 causes program execution to
resume after 360 seconds, regardless of the
specified value.
• The ClassPad’s Auto Power Off function is disabled
during a pause caused by the Wait command.
• If the Auto Power Off trigger time is reached during
the pause, program execution resumes.
While~WhileEnd Ctrl - While
Syntax:
While<expression> : [<statement>] … : WhileEnd
• <expression> is a condition that evaluates to true or
false.
Function: Repeats the specified statements as long
as the condition is true.
Description:
• The statements between While~WhileEnd are
repeated as long as the condition is true. When the
condition becomes false, execution jumps to the
next command after the WhileEnd command.
• Since the condition comes after While, the condition
is evaluated before the loop is started.
• You can use a multi-statement command (:) in place
of the carriage return to separate statements.
• Do not use the Goto command to exit a
While~WhileEnd loop.
WhileEnd Ctrl - While
See While~WhileEnd.
X
xor Ctrl - Logic
See “Bitwise Operations” (page 60).
xyLine Misc - Statistics(1) - Graph
Function: Used as a StatGraph command argument
to specify an option. See StatGraph.
Z
ZAuto Misc - Graph&Table(1) - Zoom
Syntax: ZAuto
Function: Performs Auto Zoom.
ZFactor Misc - Graph&Table(1) - Zoom
Syntax: ZFactor<
xfactor value>, <yfactor value>
Function: Specifies the Factor Zoom Factor value.
To Next Page
Loading...
Need help?
General
