20050401
The message “Complete!” appears when the backup operation is finished.
Press J to return to the screen displayed in step 1.
The following message appears if there is already backup data in the storage memory.
Press 1(Yes) to back up the data, or 6(No) to cancel the backup operation.
A “Memory Full” occurs when there is not enough space available in the storage memory to
complete the backup operation.
u To restore backup data to the main memory
1. On the initial MEMORY mode screen press 4(BKUP).
•On the screen that appears, you can confirm whether or not there is backup data in
the storage memory.
2. Press 2 (LOAD).
This displays the folder selection screen.
3. Use f and c to select a folder.
12-7-15
MEMORY Mode
To Next Page
Loading...
