20050401
○○○○○
Example To determine the derivative at point x = 3 for the function
y = x
3
+ 4x
2
+ x – 6, with a tolerance of “tol” = 1E – 5
Input the function f(x).
AK4(CALC)2(d/dx)vMd+evx+v-g,
Input point x = a for which you want to determine the derivative.
d,
Input the tolerance value.
bE-f)
w
<Math>
A4(MATH)4(d/dx)vMde
+evx+v-ged
w
# In the function f(x), only X can be used as a
variable in expressions. Other variables (A
through Z excluding X, r,
θ
) are treated as
constants, and the value currently assigned to
that variable is applied during the calculation.
# Input of the tolerance (tol) value and the
closing parenthesis can be omitted. If you omit
tolerance (tol) value, the calculator automati-
cally uses a value for tol as 1
E-10.
# Specify a tolerance (tol) value of 1E-14 or
greater. An error (Time Out) occurs whenever
no solution that satisfies the tolerance value
can be obtained.
# In the Math input mode, the tolerance value is
fixed at 1
E-10 and cannot be changed.
# Inaccurate results and errors can be caused by
the following:
- discontinuous points in
x values
- extreme changes in
x values
- inclusion of the local maximum point and local
minimum point in
x values
- inclusion of the inflection point in
x values
- inclusion of undifferentiable points in
x values
- differential calculation results approaching zero
2-5-3
Numerical Calculations
20070101
To Next Page
Loading...
Need help?
General
