20070201
# Pressing 6('MAT) while a calculation
result is displayed enters the Matrix Editor,
which you can use to edit and view the
contents of matrices.
# The following V-Window settings are used for
drawing the graph.
Xmin = 0, Xmax = 11.5, Xscale = 2,
Ymin = –0.1, Ymax = 0.5, Yscale = 0.1
# Executing an analysis function automatically
stores the χ
2
and p values in alpha variables
C and P, respectively.
6-5-19
Tests
After setting all the parameters, use c to move the highlighting to “Execute” and then press
one of the function keys shown below to perform the calculation or draw the graph.
• 1(CALC) ... Performs the calculation.
• 6(DRAW) ... Draws the graph.
Calculation Result Output Example
χ
2
................................. χ
2
value
p .................................. p-value
df ................................. degrees of freedom
You can use the following graph analysis functions after drawing a graph.
• 1(CHI) ... Displays χ
2
value.
Pressing 1(CHI) displays the χ
2
value at the bottom of the display, and displays the pointer
at the corresponding location in the graph (unless the location is off the graph screen).
Press J to clear the χ
2
value.
• 2(P) ... Displays p-value.
Pressing 2(P) displays the p-value at the bottom of the display without displaying the
pointer.
Press J to clear the p-value.
To Next Page
Loading...
Need help?
General
