20070201
u To use copy and paste to draw a graph
1. Perform steps 1 through 7 under “To create a
Graph strip” (page 10-3-13) to create a Graph strip
with the title “Graph draw”.
• After completing step 7, check to make sure
the Graph strip is highlighted on the eActivity
workspace screen. If it isn’t, use the f and c
cursor keys to move the highlighting to the Graph
strip.
2. Press 3(INS)1(TEXT) to input a text line.
3. Enter the following expression into the text line: Y = X
2
– 1.
4. Use the f and c cursor keys to move the cursor to the expression you just input
(Y = X
2
– 1), and copy it to the clipboard.
• See “To specify the copy range” (page 1-3-5) for details about how to copy text to the
clipboard.
5. Use the f and c cursor keys to move the
highlighting to the Graph strip, and then press w.
• This will graph the function currently stored in
“Graph draw ” strip memory.
6. Press !j(PASTE).
• This will graph the function that is on the
clipboard (Y = X
2
– 1).
7. To return to the eActivity workspace screen, press !a(').
8. Press w again to call up the graph screen.
• This will re-graph the function currently stored in “Graph draw” strip memory.
10-3-17
Inputting and Editing eActivity File Data
# Though the above example uses an
expression that was copied from the eActivity
workspace screen, you can also copy an
expression from another application and then paste
it into eActivity.
To Next Page
Loading...
Need help?
General
