120
Appendix
When things don’t go right...
Troubleshooting
Problem Possible Cause and Recommended Action
Power Supply
Power does not turn
on.
1)The battery of new camera is not charged. Charge the
battery before using the camera.
2)The camera battery may be dead. Charge the battery (page
15). If this does not resolve the problem, contact your retailer
or a CASIO authorized service center.
The camera
suddenly powers
down.
1)The camera is designed to turn off automatically after no
operation is performed for about five minutes. Turn power
back on.
2)The battery may be dead. Charge the battery (page 15).
3)The camera’s protection function may have activated
because camera temperature is too high. Turn off the
camera and wait until it cools down before trying to use it
again.
Power will not turn
off. Nothing
happens when a
button is pressed.
Hold down the shutter button for at least 10 seconds to reset
the camera.
Charging
The operation lamp
does not light red
and the battery
won’t charge.
1)Unplug the USB cable from the camera and then plug it back
in again.
2)Make sure the camera is turned off when you connect the
USB cable. Charging may not start if you connect the USB
cable while power is turned on.
Image Recording
Image is not
recorded when the
shutter button is
pressed.
1)If the camera is in the PLAY mode, touch “ ” (REC) to enter
the REC mode.
2)If the message “Memory Full” appears, transfer images to
your computer, delete images you no longer need, or use a
different memory card.
Images are out of
focus.
1)If the lens is dirty, clean it off.
2)The subject may not be in the center of the focus frame when
you compose the image.
3)You may be moving the camera when shooting. Place the
camera on a tabletop or some other stable surface, or find
some way to fix the camera in place.
4)You may be pressing the shutter button all the way without
waiting for Auto Focus. Half-press the shutter button and
allow enough time for Auto Focus to focus.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
