42
Recording Movie
Minimizing the Effects of Camera Movement during Movie Recording
You can configure the camera to minimize the effects of camera movement during
movie recording.
IMPORTANT!
• Spending a long time using movie recording will cause the camera to become
slightly warm to the touch. This is normal and does not indicate malfunction.
• Movie recording also records audio. Note the points below
when shooting a movie.
– Take care that the microphone is not blocked by your
fingers, etc.
– Good audio recording results are not possible when the
camera is too far away from what you are trying to
record.
• Shooting movies for long periods in areas where
temperature is relatively high can cause digital noise (dots of light) to appear in the
movie image. A rise in the camera’s internal temperature also may force movie
recording to stop automatically. If this happens, stop recording and allow the
camera to cool down, which should cause normal operation to resume.
• Use of the camera’s built-in memory or certain types of memory cards can slow
down processing speeds. In particular, high-quality movies may not be able to be
stored correctly. A slow memory card can take too much time to record data and
result in breaks in the image and/or audio during playback. When this happens
“ ” (Movie Stop) will be “ ”.
• SR Zoom (page 39) is disabled during movie recording.
• The effects of camera movement in an image become more pronounced when you
shoot close up or with a large zoom factor. Because of this, stabilizing the camera
by placing it on a level surface, etc. is recommended.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
