83
Using the Camera with a Computer
3. Double-click the camera’s drive icon.
The camera’s operation lamp will light green at this time. In this mode, your
Macintosh recognizes the memory card loaded in the camera (or the camera’s
built-in memory if it does not have a memory card loaded) as a drive. The
appearance of the drive icon depends on the Mac OS version you are using.
4. Drag the “DCIM” folder to the folder to which you want to copy it.
5. After the copy operation is complete, drag the drive icon to Trash.
6. Disconnect the camera from the computer.
Close the camera to turn off power. After checking to make sure that the
operation lamp is unlit or lit red, disconnect the USB cable.
. To view copied images
1. Double-click the camera’s drive icon.
2. Double-click the “DCIM” folder to open it.
3. Double-click the folder that contains the images you want to view.
4. Double-click the image file you want to view.
• For information about file names, see “Memory Folder Structure” on page 85.
• An image that was rotated on the camera will be displayed on your Macintosh
screen in its original (unrotated) orientation.
. Movie Playback Precautions
• To play back a movie, first save it to your computer and then double-click the movie
file. Proper movie playback may not be possible for data accessed over a network,
from a memory card, etc.
• Proper movie playback may not be possible on some Macintosh models. If you
experience problems, try the following.
– Shut down other applications that are running.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
