(Status tab) as GOOD, MEDIUM, or POOR. If the signal strength is POOR, please try SIM
cards from other cellular operators or try other uplink solutions. Only MultiTech cellular
modems, HW cellular modems and ConnectedIO EM1000T-VZ-CAT1 support the
showing of cellular signal strength.
Below is the mapping for MultiTech and HW cellular modems.
What is more, from firmware 2.0.3, the user can see IMEI and IMSI on AC (AC-
>Gateway->Details->Uplink) and gateway console for MultiTech cellular modems and
HW MS2131i-8. If the user changed the default setting of parameter “Device” for
MultiTech cellular modems, the value of RSSI, IMSI and IMEI may become wrong.
Cassia gateway supports USB cellular modem auto recovery function. After setting
“Recover Action” to ON, Cassia gateway will power reset the USB cellular modem
(X2000) or reset the USB interface (other gateways) if it can’t reconnect to the cellular
network in 10 minutes. For an AC managed gateway, if the cellular connection can’t be
recovered in one hour, the gateway will soft reboot automatically. All cellular modems
connected by USB port are able to support this function.
From firmware 2.1.1, the user can choose to not using LTE lower frequency bands
(lower than 1GHz) on below USB cellular modems by switching off option “LTE Low
Frequency Band”. This function will increase the stability for the gateway using below
USB cellular modems.
•
MultiTech MTCM-LNA3-B03 (for AT&T, Verizon and Verizon VPN)
•
MultiTech MTCM2-L4G1 (for Vodafone, Telefonica and Orange)
•
Soracom Onyx SC-QGLC4-C1
5.3.
Container Tab
From firmware 1.3 and above, Cassia’s Bluetooth gateway E1000, X1000, and X2000
support custom applications in the container (OS is Ubuntu 16.04.3).
To Next Page
Loading...
