Cattron™ MP96/48 Series Portable Remote Control Systems
User Manual
68C-MP96/48-RD-EN
Version 006
MORE THAN ONE REMOTE CONTROL SYSTEM MAY BE USED AT, AROUND OR NEARBY
YOUR OPERATING FACILITY. THEREFORE, IF THE WRONG ADDRESS AND OPERATING
FREQUENCY IS PROGRAMMED INTO A REMOTE CONTROLLER, OTHER EQUIPMENT
LOCATED AT, AROUND OR NEARBY YOUR FACILITY MAY BECOME OPERATIONAL.
FAILURE TO COMPLY WITH THIS WARNING MAY RESULT IN THE UNDESIRED OPERATION OF
OTHER EQUIPMENT.
AFTER CHANGING AN ADDRESS OR FREQUENCY SELECTOR SWITCH, YOU MUST FIRST
ENSURE THE TARGETED MACHINE IS UNDER REMOTE CONTROL BEFORE OPERATING ANY
MOTION FUNCTION SWITCH. THIS MAY BE ACCOMPLISHED BY OPERATING A NON-MOTION
FUNCTION SWITCH ON THE REMOTE CONTROLLER SUCH AS A HORN OR LIGHT.
FAILURE TO COMPLY WITH THIS WARNING MAY RESULT IN THE UNDESIRED OPERATION OF
OTHER EQUIPMENT.
ON CAB AND REMOTE OPERATED CRANES OR CARRIERS, AN AUDIBLE OR VISUAL
WARNING MEANS SHALL BE PROVIDED. IN ADDITION, ALL EQUIPMENT SHALL HAVE AUDIO
OR VISUAL ALARM INDICATIONS MEETING GOVERNMENTAL REQUIREMENTS.
WHEN INSTALLED TO YOUR CONTROLLER, NEVER DISABLE THE PUSH-TO-OPERATE (PTO)
BAR SWITCH.
DE-ENERGIZE AND TAG OUT ALL SOURCES OF ELECTRICAL POWER BEFORE CARRYING
OUT TOUCH TESTS ON EQUIPMENT. FAILURE TO PROPERLY DE-ENERGIZE EQUIPMENT
MAY RESULT IN DEATH OR SERIOUS INJURY FROM ELECTRIC SHOCK.
HIGH VOLTAGE MAY BE PRESENT ON RELAY OUTPUT TERMINALS. EXERCISE CAUTION
WHEN WORKING NEAR THE RELAY OUTPUT BOARDS. FAILURE TO OBSERVE THIS
WARNING MAY RESULT IN DEATH OR SERIOUS INJURY FROM ELECTRIC SHOCK.
REMOVE POWER FROM THE CRANE OR MACHINE MOTORS BEFORE PERFORMING ASO
TESTS. THESE TESTS REQUIRE THE ENERGIZING OF THE OUTPUT RELAYS USING
JUMPERS. ENERGIZING THE RELAYS WHILE POWER IS APPLIED TO THE SYSTEM MOTORS
MAY RESULT IN UNDESIRED MOVEMENT OF THE CRANE OR MACHINE. IN ADDITION,
DAMAGE TO THE CIRCUIT BOARDS MAY RESULT IF THE TEST JUMPER CONTACTS THE
WRONG COMPONENT.
To Next Page
Loading...
Need help?
General
