The Cattron Two-Step Electro-Hydraulic Brake Package provides safety for the crane system. When properly
installed, the brake package will not allow operation of the crane unless sufficient brake pressure exists to stop
the crane in case of an emergency. Brake pressure is stored using a hydraulic accumulator. Any loss of power
automatically results in application of the crane brake. This provides braking even when crane power is lost or
turned off for a short period of time.
For more information on our Two-Step Electro-Hydraulic Brake Package, please contact Cattron at
www.cattron.com/contact.
8.2.2 Transfer Switch Schematic
A schematic diagram for the Transfer Switch is provided below. Refer to the Transfer Switch section of this
manual for a description and typical wiring diagram.
To Next Page
Loading...
Need help?
General
