Page 12 of 45
7 Operation
7.1 Common functional problems
In case of a shutdown it must be ensured that the plant has stopped completely before attempting to remedy
the error.
- Check the setup. If there is no error then call a service employee or contact Ceetec.
7.2 Operation
Before start-up the supplier instruction manual for the paint product must be read in order to make sure any
safety precautions in connection with the use of the product can be adhered to.
At all times the temperature of the paint product must not exceed the flash point of minus 10
º
C.
We recommend using the paint machine in a ventilated room or outdoors. We also refer to the supplier
instruction manual for information about necessary ventilation.
When the machine is in use you should avoid putting hands and similar into the intake of the machine as
there is a danger of crushing.
Also see sections 8 and 9
To Next Page
Loading...