Centa CENTAX-G - Page 23

Assembly and operating instructions
CENTAX-G
020G-00050…00090-F.10
M020-00009-EN
Rev. 4
CENTA Antriebe Kirschey GmbH 23 / 52
IMPORTANT
This assembly instruction describes the mounting of several design.
Mount the coupling as appropriate for the supplied design (see installation drawing).
 Mount the coupling according to the following described order as appropriate
for the supplied design. For delivered design and built-in parts, see
installation drawing.
 Mounting the hub (3), see chapter 6.3.
 Mounting the adapter (17), see chapter 6.4.
 Aligning the units, see chapter 5.
 Positioning the membrane (1.2.1), see chapter 6.6.
 Positioning the ring (1.4) inside the rubber element (1.1),
see chapter 6.7.
 Mounting the pre-mounted rubber element (F) to the flywheel,
see chapter 6.9.
 Mounting the rubber element (1.1), the ring (20; if existing) and the
adapter (4) to the flywheel, see chapter 6.10.
 Mounting the ring (1.4), see chapter 6.11.
 Mounting the membrane (1.2.1), see chapter 6.12.
 Connecting the rubber element (1.1) and the membrane,
see chapter 6.13.
 After completed mounting, see chapter 6.14.