Centa CENTAX-G - CENTA Data Sheet D020-900 Declaration of Incorporation According to the EC Machinery Directive 2006;42;EC

Assembly and operating instructions
CENTAX-G
020G-00050…00090-F.10
M020-00009-EN
Rev. 4
CENTA Antriebe Kirschey GmbH 52 / 52
11.2 CENTA data sheet D020-900
Declaration of incorporation according to the EC Machinery
Directive 2006/42/EC, Appendix II B
Manufacturer:
CENTA Antriebe
Kirschey GmbH
Bergische Strasse 7
42781 Haan / GERMANY
Contact:
Phone +49-2129-912-0
Fax +49-2129-2790
centa@centa.de
www.centa.info
We herewith declare that the incomplete machine
Product:
Highly elastic coupling CENTAX-G
Model / series code:
CX-G / 020G
Installation size:
50…90
Design:
all
Serial number:
according to shipping documents, if applicable
- provided this is possible as far as the scope of supply is concerned - complies
with the following basic requirements of the Machinery Directive 2006/42/EC
Appendix I, subchapters 1.1.2, 1.1.3, 1.1.5, 1.3.2, 1.3.3, 1.3.4 and 1.5.4.
In addition, we declare that the special technical documents for this incomplete
machine were compiled according to Appendix VII Part B and undertake to
forward these to the market monitoring authorities by request via our
"Documentation Department".
Commissioning of the incomplete machine is interdicted until the incomplete
machine has been incorporated in a machine and the latter complies with the
provisions of the EC Machinery Directive and the EC Declaration of Conformity
according to Appendix II A is on hand.
The declaration is invalidated by every modification to the delivered parts.
Authorised representative for the
compilation of the relevant technical
documents:
by order of Gunnar Anderseck
(Authorised Person Documentation)
Declaration of incorporation was issued:
Haan, 19.11.2009
by proxy Dipl.-Ing. Jochen Exner
(Design Management)