CENTURION SYSTEMS R6 - R6 Operator Installation Guide; Simplified Pedestal Mounting

page 15 www.centsys.com
OPERATOR INSTALLATIONSECTION 6
6. Operator Installation
6.1. Simplied Pedestal Mounting Position
Thesetablescanbeusedasaquickalternativetothesetupproceduresshown
on pages 16 to 23.
GATE OPEN ANGLE = 90°
Arm Length A B C
250 235 385 354
400 340 700 565
500 410 915 705
GATE OPEN ANGLE = 100°
Arm Length A B C
250 300 325 320
400 440 615 520
500 540 810 650
GATE OPEN ANGLE = 110°
Arm Length A B C
250 360 265 300
400 540 525 485
500 670 700 605
TABLE 4
FIGURE 5
1. All dimensions shown in millimetres.
2. All dimensions referenced to hinge point.
3. Gate thickness assumed to be 40mm.
4. Distance depends on pillar size. Check carefully before installation.
Pillar
Pedestal
Gearbox
cover
Drive arm
GATE CLOSED
GATE OPEN
Hinge point
Gate open
angle
B
40mm
Seee notes
See Note 4
A C
Gate
bracket