CENTURION SYSTEMS R6 - Pedestal Positioning (Gate Inward Opening)

page 17 www.centsys.com
Step 2
Swing the gate to the desired
opening position (70 - 120 degrees)
and make the second mark “S2” on
the ground.
Step 3
Measure the distance “Z”, between
“S1” & “S2” in mm, then using “Z”,
look up gate opening Angle and
dimension C for size of Drive Arm
supplied (see Table 5).
FIGURE 8
S1
S2
Z
6.3.1. Pedestal Positioning (Gate Inward Opening)
Z
GATE OPENING
ANGLE
DIMENSION C FOR DRIVE ARMS
250mm 400mm 500mm
1147 70° 436 697 872
1161 71° 431 689 861
1176 72° 425 681 851
1190 73° 420 672 841
1204 74° 415 665 831
1218 75° 411 657 821
1231 76° 406 650 812
1245 77° 402 643 803
1259 78° 397 636 795
1272 79° 393 629 786
1286 80° 389 622 778
1299 81° 385 616 770
1312 82° 381 610 762
1325 83° 377 604 755
1338 84° 374 598 747
TABLE 5
OPERATOR INSTALLATIONSECTION 6
Say “Z” is measured as
1482mm, then the closest
Z value in table = 1486mm.
Dimension “C” for a 400mm
Drive Arm is therefore
538mm.