Dual Site with four Switches
Quantum Maestro Getting Started Guide|169
Step Instructions
n
To create a new Security Group when the SMO Image Cloning is
disabled
, follow the
procedure below.
Procedure
a. Create a new Security Group that contains interfaces and Security
Appliances only from Site 1.
b. Connect to the command line of the Security Group over SSH at <IP
Address of Security Group>.
When you log in, the Gaia gClish opens by default.
Important - This connection goes through the Quantum Maestro
Orchestrator's management interface you assigned to this
Security Group.
c. Configure the total number of Sites:
set smo security-group site-amount 2
d. Add to this Security Group the Security Appliances from Site 2.
To Next Page
Loading...
