Fb.01
Fb.02
Fb.03
Fb.04
Fb.05
Fb.06
0:2400BPS
1:4800BPS
2:9600BPS
3:19200BPS
4:38400BPS
0: no parity (8-N-2) for RTU
1: Odd parity (8-O-1) for RTU
2: Even parity (8-E-1) for RTU
3: No parity (7-N-2) for RTU
4: Odd parity (7-O-1) for RTU
5: Even parity (7-E-1) for RTU
6: No parity (8-N-2) for ASCII
7: Odd parity (8-O-1) for ASCII
8: Even parity (8-E-1) for ASCII
9: No parity (7-N-2) for ASCII
10: Odd parity (7-O-1) for ASCII
11: Even parity (7-E-1) for ASCII
12: No parity (8-N-1) for RTU
( 0 ~ 200) m s
( 0. 0 ~ 100.0) s
0: alarm and stop freely
1: No alarm and continue to run
2: No alarm, stop according to the shutdown mode
(only in the communication control mode)
3: No alarm, stop according to the shutdown mode
(under all control modes)
0: There is a response to the write operation (the
inverter responds to the write commands of the
host computer)
1: No response to write operation (the inverter only
responds to the read command of the host
computer, but does not respond to the write
command. This method can improve
communication efficiency)
2
12
5ms
0.0s
1
1
Communication baud rate setting
Data bit check setting
Communication response delay
Transport Error Handling
Communication processing
action selection
Communication timeout fault time
Fb.00
1～247 1
Local mailing address
Fb group serial communication parameter group
function
code
name
Parameter Description
Defaults
Change
FC group reserved parameter group
FC.00
– –
reserve
Fd.00
Fd.01
Fd.02
Fd.04
Fd.05
Fd.06
Fd.07
Fd.08
Fd.09
Fd.03
(0.00 ~ +600.00)Hz
(0.00 ~ +600.00)Hz
(0.00 ~ +600.00)Hz
(-300.0～+300.0)% (relative to the rated torque of
the motor)
(0.00 ~ +600.00)Hz
(0 ~ 480) V
(0.0 ~ 3000.0) A (relative to 0.0 ~ 3.0) Ie)
(0 ~ 60000)rpm
(-300.0 ~ +300.0)% (compared to twice the rated
torque of the motor)
(0.00 ~ +600.00)Hz
0.00Hz
0.00Hz
0.00Hz
0.0%
0.00Hz
1
0.0A
0rpm
0.0%
0.00Hz
Main given set frequency
Auxiliary given set frequency
set frequency
Torque given
Output frequency
The output voltage
Output current
Operating speed
Output torque
Frequency command (after
acceleration and deceleration)
Fd group state display parameter group
101
NVF2G-S Series Inverter User's Guide
To Next Page
Loading...