Chroma 11021 - Page 50

LCR Meter 11021 / 11021-L User’s Manual
5-10
Function: The return value can be used with the command
CALCulate{1|2}:MATH:EXPRession:NAME.
Query Syntax: CALC1:MATH:EXPR:CAT?
Return Data: DEV,PCNT
(9) Command: CALCulate{1|2}:MATH:EXPRession:NAME
Parameter: {DEV|PCNT}
Return: {DEV|PCNT}
Function: It sets or queries the expression of value.
Syntax: CALC1:MATH:EXPR:NAME DEV
Query Syntax: CALC1:MATH:EXPR:NAME?
Return Data: DEV
(10) Command: CALCulate{1|2}:MATH:STATe
Parameter: {ON(1) |OFF(0) }
Return: {1|0}
Function: It sets or queries if command CALCulate{1|2}:MATH:EXPRession:NAME
is enabled for operation.
Description: ON (1) Enable the operation.
OFF(0) Disable the operation.
Syntax: CALC1:MATH:STAT ON
Query Syntax: CALC1:MATH:STAT?
Return Data: 1
(11) Command: CALCulate{1|2}:PATH?
Parameter: None
Return: FORM, MATH, LIM
Function: It follows the execution path of CALCulate subsystem for return.
Query Syntax: CALC1:PATH?
Return Data: FORM,MATH,LIM
DATA Command Set
(1) Command: DATA [:DATA]
Parameter: {COMPARE the center data of primary parameters (reference data)
(NR3)}
Return: The COMPARE center data of primary parameters, the format is (NR3)
Function: It sets or querys the center data of primary parameters in COMPARE
mode. If the data of primary parameter is 100, send the command
DATA:[DATA] 100;
Syntax: DATA 0.0009E-12
Query Syntax: DATA?
Return Data: 9.0000000E-16
FETCh? Command
(1) Command: FETCh?
Parameter: None
Return: <STATE>, <DAT1>, <DAT2>, <CMP1>, <CMP2>
Function: It retrieves the measured result got by INITiate command.
Description:
<STATE> Measurement State
0 Normal
1 Over load (Range selected error)