Local Operation
Von POINT
VOLTAGE: 3.50V
Set Von latch. There are two operation modes for Von control. Von latch ON means the
Load will sink current continuously when it reaches Von voltage. Von latch OFF means the
Load will stop sinking current when UUT voltage is under Von voltage. The default setting
of Von latch is OFF. Figure 4-4 and 4-5 show the Von LATCH ON and OFF current
waveform respectively.
Von LATCH
1:ON 2:OFF
aCAUTION
If Von is set to 0V, the Load circuit will be ON in spite of no UUT. This will get overshoot
spike. If a UUT is applied, the overshoot may damage the UUT regardless of how small
setting the Load current specified. So, do not set Von to 0V.
Figure 4-4 Von LATCH ON Current Waveform
4-11
To Next Page
Loading...
