Local Operation
4.2.7 Recalling Files
Press RECALL to recall files from 1 to 101. Files 1 to 100 are user data. File 101 is the
factor set state. After a file is recalled, the display will go to mode editor for you to edit or
view the file. Press RECALL the display will show the file No. recalled last time. The
default file No. is 2 when the mainframe is powered on.
Press RECALL, 3, ENTER to recall file number 3.
RECALL FILE
FILE NO:
3
The data of all channels will be recalled when you execute file recall.
4.2.8 Saving File/Default/Program
There are 100 file locations (1 to 100) for you to save files. Press SAVE, 2, 0, ENTER to
save a file to location 20.
SAVE FILE
FILE NO: 20
Press SAVE, ▼ until the display shows as below. The DEFAULT state is used for
Electronic Load after power-on. Press 1 to save the DEFAULT to EEPROM.
SAVE DEFAULT
1:YES 2:NO
Press SAVE, ▼ until the display shows as follows. Press 1 to save the program.
SAVE PROGRAM
1:YES 2:NO
4.2.9 Going To Local
The SHIFT key operates as local key, LCL, when Electronic Load is in remote mode. You
can press LCL key to go to local operation when Load is in remote state. In local operation,
SHIFT key operates as shift key.
4-15
To Next Page
Loading...
Need help?
General
