utilized in this application requires unique guidelines that must be adhered to.
Appearance-
• The textured finish differs from a smooth finish typically found on closure panels.
• The texture is produced from the casting of the component as compared to smooth stamped sheet metal.
• This finish is completely normal and acceptable.
• Do not remove the textured finish to produce a smooth finished appearance.
Workability-
• Do not grind the material, it will create combustible magnesium residue.
• Do not make any repairs to liftgate inner panel other than for refinishing purposes.
• Any sanding of the component is to be done with a scuff pad not a sanding disc. The only exception is as
prescribed in the liftgate outer panel procedure.
• Refinish per paint manufacturer’s recommendations.
Liftgate Outer Panel
Overview: The liftgate outer panel can be replaced if necessary. Special care needs to be taken in regards to the
liftgate outer panel made of aluminum and the inner magnesium panel. For more information on the liftgate inner
panel refer to Liftgate Inner Panel DO NOT REPAIR
(Refer to 31 - Collision/Standard Procedure/Non-Structural
Sheet Metal Repair/Liftgate Inner Panel DO NOT REPAIR).
31 - 22 31 - Collision Information RU
To Next Page
Loading...
