#08891 should be applied to all interior cavities, weld flanges, hem flanges as well as any are affected by the repair
especially where any type of welding was performed. Inner panel corrosion protection should be applied using
"pressure pot" equipment with wands which provide 360-degree material coverage for closed cavities, and
directional spray wands for visible coverage (Mopar kit #04271235). Additionally, the corrosion protecting material
must be applied in two coats with a minimum 30-minute flash time between applications.
Wheel wells and underbody panels which have been involved in the repair process should also have a final
undercoating applied. Use Mopar No. 05093417AA, or equivalent, and apply with "pressure pot" style application
equipment.
Following this arrangement, choice of materials, and proper application, the repaired vehicle should be as well
protected against corrosion as it was prior to the repair.
Specifications
RU 31 - Collision Information 31 - 53
To Next Page
