Body Side Aperture
NOTE: Right side shown, left side typical
NOTE: The Cowl Side Hinge Pillar area is dedicated to where it is to be sectioned, as compared to the
general locations within the outlined areas.
1 - Outer Body Side Aperture (270 MPa)
2 - Outer Body Side Aperture Hinge Pillar Sectioning Location
The Outer Body Side Aperture has many areas in which it may be sectioned in.
The cowl side is to be sectioned above the lower door hinge fastener holes. All other outlined areas represent
general sectioning areas and may be sectioned within.
NOTE: To prevent warping, apply 25 mm. (1 in.) stitch welds until the sectioning joint is completely
welded.
A Butt-joint with a 13 mm (0.5 in.) welded backer panel is to be used in all sectioning areas of the outer body side
aperture
Outer Body Side Aperture
RU 31 - Collision Information 31 - 43
To Next Page
Loading...
