3-4 Turning Up the System
5150 Service Aggregation Switch Hardware Installation and Start-up Manual
009-3222-001 Standard Revision H
Copyright
©
2012-2015 Ciena
®
Corporation July 2015
You can configure the remote management interface directly by using this
procedure, or automatically by using DHCP. See “Configuring an Interface
using DHCP” on page 3-5. The default priority for the remote management
interface defaults to 7 and is not configurable.
Note: The local and remote management interfaces cannot be configured
to the same IP subnet.
For more information on provisioning commands for the remote interface, see
the 39XX/51XX Command Reference.
For a procedure see “Configuring the Remote Management Interface” on
page 3-13.
Accessing the CLI Using Telnet
Once the remote interface is configured with a valid IP address, you can
access the device through Telnet.
The Telnet client must have a route set up to allow access to the device. See
step 3 of “Configuring the Remote Management Interface” on page 3-13.
Note: A maximum of 10 Telnet sessions can be connected at the same
time.
For a procedure see “Accessing the CLI using Telnet” on page 3-14.
Configuring the Local Management Interface
The local management interface accepts untagged packets only; all tagged
packets are dropped.
The factory default IP addresses and subnets for 5150 are documented in
39XX/51XX Product Fundamentals. The default values are automatically
entered if the switch is reset to factory defaults.
You can configure the local management interface directly by using this
procedure, or automatically by using DHCP. See “Configuring an Interface
using DHCP” on page 3-5.
Note: The local and remote management interfaces cannot be configured
to the same IP subnet.
To Next Page
Loading...
