Turning Up the System 3-3
5150 Service Aggregation Switch Hardware Installation and Start-up Manual
009-3222-001 Standard Revision H
Copyright
©
2012-2015 Ciena
®
Corporation July 2015
• super (read/write)
• diag (read/write)
Deleting a User Account
After you have created new user accounts for all access levels described in
Table 3-1, it is recommended that you delete the default user accounts. At
least one user with super user privileges must be configured on the device.
See the related procedures:
• “Creating a new user account” on page 3-8
• “Deleting a user account” on page 3-11
Managing Licenses
A license is a permit to use a feature or set of features. The physical license
consists of a cover sheet and a copy of the license terms. The cover sheet has
a label affixed to it identifying the license model number and license key. The
licenses are shipped with the hardware.
Note: It is strongly recommended that you keep a copy of your license
keys in a safe place.
You need to install the license key on the 5150 to activate the features
associated with the license.
You can install multiple licenses on the 5150, as summarized in Table 3-2.
For more information on associated features and managing software license
keys, see 39XX/51XX Software Management and Licensing .
For a procedure see “Managing Licenses” on page 3-12.
Configuring the Remote Management Interface
The factory default IP address and subnet for the remote interface is
0.0.0.0:0.0.0.0. These values will be entered if the system is reset to factory
defaults.
Table 3-2
License Key Summary
Product Advanced-
10G
Advanced-
Ethernet
Advanced-
OAM
Advanced-
Security
Advanced-
Sync
MPLS PBB-TE
5150 x x x x x x
To Next Page
Loading...
