Ciena 5150 - Page 52

3-8 Turning Up the System
5150 Service Aggregation Switch Hardware Installation and Start-up Manual
009-3222-001 Standard Revision H
Copyright
©
2012-2015 Ciena
®
Corporation July 2015
Procedure 3-2
Creating a new user account
Step Action
1 Create a new user account:
2 Display the accounts in the system:
user show
3 Repeat step 1 and step 2 for every remaining user account you want to
create.
4 When you are finished creating user accounts, save and complete the
process:
configuration save
—end—
For more information about user create command options, refer to the
Administration and Security document for the SAOS release running on the
system.
Example
This section provides examples for:
• “SAOS 6.13” on page 3-9
If you are creating
a user account in
release
Then enter
SAOS 6.13 user create user <String>
{access-level
<limited|admin|super|diag>}
echoless-password
The system prompts you to enter a password which is
displayed as you type.
Enter Password:
After you enter the password you are prompted to
verify the password string you typed. The password is
not displayed as you type.
Verify Password:
The system command prompt is displayed after you
successfully verify the password.
SAOS 6.10, 6.11 or
6.12
user create user <user>
access-level <limited|admin|super|diag>
password <password>