TRANSTIG 170Pi
TROUBLESHOOTING 6-2 Manual 0-5242
10 Fault light is on, and E-1 is
shown on the Amps display
A Fail to Safe protection has
operated in STICK mode-
VRD fault.
A Reset mains power, if fault does not
clear then have an accredited CIG-
WELD service provider repair unit.
B Fail to Safe protection has
operated in TIG mode- In-
verter fault.
B Reset mains power, if fault does not
clear then have an accredited CIG-
WELD service provider repair unit.
C External voltage has been
applied to the welding
circuit.
C Reset mains power and remove the
source of the external voltage.
Table 6-1
To Next Page
Loading...
