29
Audio Settings
Digital Out
Sets the format of the digital audio signal
from the rear panel Coaxial jack.
1 In DVD Stop mode, press SETUP.
2 Select Audio > Digital Out.
3 Choose from the following:
Bitstream - Select if the DVD+VCR is
connected to a 5.1 channel amplifier/
receiver with a Dolby Digital or DTS
decoder.
LPCM – Select if the DVD+VCR is con-
nected to a 2-channel (stereo) digital
amplifier.
Dynamic Range
Compresses the dynamic range of the
audio output (the difference between the
loudest and quietest passages) during
DVD playback.
1 In DVD Stop mode, press SETUP.
2 Select Audio > Dynamic Range.
3 Use the buttons to move the
Dynamic Range slider from OFF (no
compression) to FULL (maximum
compression).
3 - Setup
To Next Page
Loading...