Cisco 11503 - CSS Content Services Switch User Manual

Chapter 2 Specifying the CSS Boot Configuration
Configuring a Boot Configuration Record for the Passive SCM
2-16
Cisco Content Services Switch Administration Guide
OL-5647-02
Copying Configuration Information from the Active SCM to the
Passive SCM
To copy the primary and secondary boot configuration record from NVRAM of
the active SCM to the passive SCM, use the passive sync command. For the CSS
11506, the passive sync command also copies the startup- configuration file and
synchronizes the clock time from the active SCM to the passive SCM. This
command is available in boot mode.
To synchronize specific boot configuration, startup configuration, or clock time
information between the active SCM and the passive SCM in a CSS 11506, use
the following commands:
• passive sync boot-config - Copies the boot configuration record from the
active SCM to the passive SCM.
• passive sync startup-config - Copies the startup-config file from the active
SCM to the passive SCM.
• passive sync image - Copies the ADI of the boot-image file from the active
SCM to the passive SCM.
• passive sync time - Synchronizes the clock time of the passive SCM with the
active SCM.
To copy the primary and secondary boot configuration record, startup
configuration, and clock time on a CSS 11506, enter:
(config-boot)# passive sync
To copy the boot configuration record from the active SCM to the passive SCM in
a CSS 11506, enter:
(config-boot)# passive sync boot-config

Cisco 11503 - CSS Content Services Switch Specifications

General

Brand	Cisco
Model	11503 - CSS Content Services Switch
Category	Switch
Language	English