5-29
Cisco Content Services Switch Administration Guide
OL-5647-02
Chapter 5 Configuring Simple Network Management Protocol (SNMP)
Displaying the SNMP Configuration
Displaying the SNMP Configuration
After you configure SNMP, display the SNMP configuration. For example:
(config)# show running-config global
Refer to Chapter 1, Managing the CSS Software, for details on the show
running-config command and its output.
Managing SNMP on the CSS
This section describes the activities that you need to perform to manage SNMP on
the CSS. This section includes the following topics:
• Enabling SNMP Manager Access to the CSS
• Using the CSS to Look Up MIB Objects
• Reading Logs
• Setting RMON Alarms
Enabling SNMP Manager Access to the CSS
By default, the CSS enables SNMP access to its command base. You must first
create community strings using the snmp community command before you can
use SNMP in the CSS. See the “Configuring an SNMP Community” section for
details.
Note SNMP is not a secure network environment. Do not use SNMP by itself to provide
security for your network.
To Next Page
Loading...
