4-11
Cisco Content Services Switch Administration Guide
OL-5647-02
Chapter 4 Using the CSS Logging Features
Configuring Logging for a Subsystem
• level level - The log level for the message. Enter one of the levels, from 0 to
7, as shown in Table 4-4. To see a list of levels, enter:
cliLogMessage subsystem name “message” level ?
Logging ACL Activity
When you configure the CSS to log ACL activity, the CSS logs the event of the
packet matching the clause and ACL. The CSS sends log information to the
location you specified in the logging command.
Before you configure logging for a specific ACL clause, ensure global ACL
logging is enabled. To globally enable ACL logging, use the logging subsystem
acl level debug-7 command in configuration mode.
To configure logging for an ACL clause:
1. Enter the ACL mode for which you want to enable logging.
(config)# acl 7
(config-acl[7])#
2. Enable logging for:
• A new clause, by entering the log option at the end of the clause. For
example:
(config-acl[7])# clause 1 deny udp any eq 3 destination any eq
3 log
• An existing clause, by using the clause log enable command:
(config-acl[7])# clause 1 log enable
To disable ACL logging for a specific clause, enter:
(config-acl[7])#) clause 1 log disable
To globally disable logging for all ACL clauses, enter:
(config)# no logging subsystem acl
To Next Page
Loading...
