Cisco 11503 - CSS Content Services Switch User Manual

4-17
Cisco Content Services Switch Administration Guide
OL-5647-02
Chapter 4 Using the CSS Logging Features
Specifying a Log File Destination
For example, to send log information to a host at IP address 192.168.11.1 with a
facility level of 3 and a log-level of error-3:
(config)# logging host 192.168.11.1 facility 3 log-level error-3
To turn off logging to a host, enter:
(config)# no logging host
Specifying a Line for a Log File Destination
To send log information to an active CSS session, use the logging line command
and specify a valid log line on the CSS. Enter the line as a case-sensitive text
string with a maximum of 32 characters.
The CSS continues to send log information to the sys.log file on the CSS disk
(hard or Flash disk) even when the logging line command is entered. To disable
logging to the sys.log file on the CSS disk, use the logging to-disk disable
command (see the “Disabling Logging to the sys.log File on the Disk” section).
To display a list of active CSS lines, enter the logging line command as shown.
The asterisk (*) denotes your current session.
(config)# logging line ?
console Login Name: Location:local
*vty1 Login Name: admin Location:10.0.3.35
To send subsystem information to your monitor, enter:
(config)# logging line vty1
To turn off logging, enter the no logging line command.
(config)# no logging line vty1

Cisco 11503 - CSS Content Services Switch Specifications

General

Brand	Cisco
Model	11503 - CSS Content Services Switch
Category	Switch
Language	English