Cisco 11503 - CSS Content Services Switch

5-19
Cisco Content Services Switch Administration Guide
OL-5647-02
Chapter 5 Configuring Simple Network Management Protocol (SNMP)
Defining the CSS as an SNMP Agent
For example, enter:
(config)# snmp trap-type generic
(config)# snmp auth-traps
To disable reception of authentication traps, enter:
(config)# no snmp auth-traps
Configuring SNMP Enterprise Traps
By default, SNMP enterprise traps are disabled on the CSS. Use the snmp
trap-type enterprise command to enable SNMP enterprise trap types. Once you
enable enterprise traps, you can then configure the CSS to generate enterprise
traps when:
• Denial of Service attack events occur
• A login fails
• A CSS service, power supply, or reporter transitions state
• A module is inserted into a powered-on CSS chassis
• An Inter-Switch Communications (ISC) LifeTick failure message occurs
Use the no form of the snmp trap-type enterprise command to prevent the CSS
from generating a trap when a specific condition occurs.
Note Note that the CSS sends only SNMP v1 trap types.
For details on SNMP traps (and associated MIB objects) loaded as part of the CSS
software, see the “CSS SNMP Traps” section. For information on configuring
Denial of Service enterprise traps, see the “Configuring Denial of Service (DoS)”
section.
The syntax for this global configuration mode command is:
snmp trap-type enterprise {dos_attack_type {trap-threshold
threshold_value}|chmgr-module-transition|chmgr-ps-transition
|isc-lifetick-failure|isc-state-transition|login-failure|reload|redundan
cy-transition |reporter-transition|service-transition}