Chapter 1 Managing the CSS Software
Configuring Disks in a Two-Disk CSS
1-22
Cisco Content Services Switch Administration Guide
OL-5647-02
• boot-image filename - Copies the specified boot image ADI from the source
disk to the second disk. If necessary, use the show installed-software
command to view the names of the boot-images (see the “Showing Software
Information” section for details on using the show installed-software
command).
• startup-config - Copies the startup-config file from the source disk to the
second disk.
Note the following restrictions for the copy command when copying information
between two disks in the CSS:
• The source file must exist.
• An equivalent release of CSS software must be present on the destination disk
before you copy information to the disk (such as a startup-config file, a log
file, or a script). If necessary, copy the boot image to the second disk before
copying a startup-config file, log file, or script.
Showing the Disk Mapping Configurations
Use the show map command to display the mapping configuration of the two
disks in slot 0 and slot 1 in a CSS. This command displays the disk assignment of
the primary-boot record, the secondary-boot record, core dump files, and logging
output. This command is available in all modes.
For example:
(config)# show map
MSD Mapping:
Primary-Boot: 0
Secondary-Boot: 0
Core: 1
Log: 1
To Next Page
Loading...
