CHAPTER
8-1
Cisco Content Services Switch Administration Guide
OL-5647-02
8
Using the CSS Scripting Language
The CSS includes a rich Scripting Language that you can use to write scripts to
automate everyday procedures. The Scripting Language is especially useful for
writing scripts used by script keepalives for your specific service requirements.
For details on script keepalives, refer to the Cisco Content Services Switch
Content Load-Balancing Configuration Guide.
Note Commands shown in the script examples are bolded for clarity.
You can write scripts that use any command in the command line interface (CLI).
Scripts can also take advantage of logical blocks that run specific commands
based upon a set of conditionals and expressions.
This chapter contains the following major sections:
• Script Considerations
• Playing a Script
• Using the Command Scheduler
• Using the echo Command
• Using Commented Lines
• Using Variables
• Using Logical and Relational Operators and Branch Commands
• Special Variables
• Using Arrays
• Capturing User Input
To Next Page
Loading...
