Cisco 11503 - CSS Content Services Switch User Manual

5-17
Cisco Content Services Switch Administration Guide
OL-5647-02
Chapter 5 Configuring Simple Network Management Protocol (SNMP)
Defining the CSS as an SNMP Agent
For example:
(config)# snmp trap-host 172.16.3.6 sqalab1 snmpv2
To remove a specified trap host, enter:
(config)# no snmp trap-host 172.16.3.6
Configuring SNMP Trap Source
To set the Agent-Address field in the traps generated by the CSS, use the snmp
trap-source command. This command applies only to SNMPv1 and does not
apply to SNMPv2C. The syntax of this global configuration mode command is:
snmp trap-source [egress-port|management |specified source_ip_address]
The options and variable for this command are:
• egress-port - Uses the VLAN circuit IP address configured on the egress port
to set the Agent-Address field of the trap. You do not need to enter an IP
address because the address is determined dynamically by the CSS.
• management - Uses the Ethernet management port IP address to set the
Agent-Address field of the trap. This option is available only on a Cisco
11500 series CSS.
• specified source_ip_address - Allows you to enter the IP address to be used
in the Agent-Address field of the traps. Enter the IP address in dotted-decimal
notation (for example, 192.168.11.1)
For example:
(config)# snmp trap-source egress-port
To return SNMP source traps to the default of the management port IP address,
enter:
(config)# no snmp trap-source

Cisco 11503 - CSS Content Services Switch Specifications

General

Brand	Cisco
Model	11503 - CSS Content Services Switch
Category	Switch
Language	English