Cisco 11503 - CSS Content Services Switch User Manual

Chapter 4 Using the CSS Logging Features
Frequently Queried Log Messages
4-60
Cisco Content Services Switch Administration Guide
OL-5647-02
SYSSOFT-4: Event not
deliverable, msgq id =
0x865c2110, event id = 4, event
name = Ipv4RouteChangeEvent
The CSS was unable to deliver a
certain process because a queue was
full. Every message signifies that a
event has been dropped because the
queue full condition. This message
happens whenever a route change is
detected. The RIP process, the OSPF
process, the caretaker processes (one
for each SFM, which try to keep the
SFM and SCM route tables in sync),
the static route process, and the ARP
process register for this event.
Look for any routes transitioning state,
locally attached stations or servers
going up and down, or a large number
of ARP requests being performed.
SYSSOFT-7:
MPOOL:mpoolAutoAlloc:WARN->Overr
un on MPOOL 3 321
This message typically appears at boot
up as an informational message to let
you know that additional CSS memory
is being allocated. No further action is
required.
Table 4-8 Cisco 11500 Series CSS Log Messages (continued)
Log Message (sys.log: Subsystem
Name, Level, and Message) Cause and Resolution

Cisco 11503 - CSS Content Services Switch Specifications

General

Brand	Cisco
Model	11503 - CSS Content Services Switch
Category	Switch
Language	English