Cisco 3032 - Page 1341

Index
IN-43
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Smartports macros (continued)
defined
12-1
displaying 12-8
tracing 12-3
SNAP 27-1
SNMP
accessing MIB variables with
33-4
agent
described
33-4
disabling 33-7
and IP SLAs 41-2
authentication level 33-10
community strings
configuring
33-8
overview 33-4
configuration examples 33-17
default configuration 33-6
engine ID 33-7
groups 33-6, 33-9
host 33-6
ifIndex values 33-5
in-band management 1-7
informs
and trap keyword
33-11
described 33-5
differences from traps 33-5
disabling 33-15
enabling 33-15
limiting access by TFTP servers 33-16
limiting system log messages to NMS 32-10
manager functions 1-5, 33-3
MIBs
location of
A-4
supported A-1
notifications 33-5
overview 33-1, 33-4
security levels 33-3
setting CPU threshold notification 33-15
status, displaying 33-18
system contact and location 33-16
trap manager, configuring 33-13
traps
described
33-3, 33-5
differences from informs 33-5
disabling 33-15
enabling 33-11
enabling MAC address notification 6-22, 6-24,
6-25
overview 33-1, 33-4
types of 33-12
users 33-6, 33-9
versions supported 33-2
SNMP and Syslog Over IPv6 39-7
SNMPv1 33-2
SNMPv2C 33-2
SNMPv3 33-2
snooping, IGMP 24-2
software compatibility
See stacks, switch
software images
location in flash
B-25
recovery procedures 47-2
scheduling reloads 3-22
tar file format, described B-25
See also downloading and uploading
source addresses
in IPv4 ACLs
34-12
in IPv6 ACLs 35-5, 35-6
source-and-destination-IP address based forwarding,
EtherChannel
37-8
source-and-destination MAC address forwarding,
EtherChannel
37-8
source-IP address based forwarding, EtherChannel 37-8
source-MAC address forwarding, EtherChannel 37-8
Source-specific multicast
See SSM