6-58
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 6 Configuring WLANsWireless Device Access
Configuring WLANs
Figure 6-28 Interfaces > Edit Page
f.
Check the Quarantine check box and enter a non-zero value for the quarantine VLAN ID, such as
“110.”
Note Cisco recommends that you configure unique quarantine VLANs throughout your network.
If multiple controllers are configured in the same mobility group and access interfaces on all
controllers are in the same subnet, it is mandatory to have the same quarantine VLAN if
there is only one NAC appliance in the network. If multiple controllers are configured in the
same mobility group and access interfaces on all controllers are in different subnets, it is
mandatory to have different quarantine VLANs if there is only one NAC appliance in the
network.
g. Configure any remaining fields for this interface, such as the IP address, netmask, and default
gateway.
h. Click Apply to save your changes.
Step 2 To configure NAC out-of-band support on a WLAN or guest LAN, follow these steps:
a. Click WLANs to open the WLANs page.
b. Click the ID number of the desired WLAN or guest LAN. The WLANs > Edit page appears.
c. Click the Advanced tab to open the WLANs > Edit (Advanced) page (see Figure 6-29).
To Next Page
Loading...
Need help?
General
