EasyManuals Logo

Cisco 4400 Series User Manual

Cisco 4400 Series
796 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #383 background imageLoading...
Page #383 background image
7-11
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 7 Controlling Lightweight Access Points
Configuring Authentication for Access Points
Step 4 In the Password and Confirm Password fields, enter the password that is to be inherited by all access
points that join the controller.
Note You must enter a strong password in these fields. Strong passwords have the following
characteristics:
- They are at least eight characters long.
- They contain a combination of upper- and lowercase letters, numbers, and symbols.
- They are not a word in any language.
Step 5 Click Apply to send the global authentication username and password to all access points that are
currently joined to the controller and to any that join the controller in the future.
Step 6 Click Save Configuration to save your changes.
Step 7 If desired, you can choose to override the global authentication settings and assign a unique username
and password to a specific access point. Follow these steps to do so:
a. Click Access Points > All APs to open the All APs page.
b. Click the name of the access point for which you want to override the authentication settings.
c. Click the Credentials tab to open the All APs > Details for (Credentials) page (see Figure 7-4).
Figure 7-4 All APs > Details for (Credentials) Page
d.
Under 802.1x Supplicant Credentials, check the Over-ride Global Credentials check box to
prevent this access point from inheriting the global authentication username and password from the
controller. The default value is unchecked.
e. In the Username, Password, and Confirm Password fields, enter the unique username and password
that you want to assign to this access point.
Note The information that you enter is retained across controller and access point reboots and
whenever the access point joins a new controller.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 4400 Series and is the answer not in the manual?

Cisco 4400 Series Specifications

General IconGeneral
Product TypeWireless LAN Controller
ManageableYes
Management PortYes
Power over Ethernet (PoE)No
Operating Temperature32 to 104°F (0 to 40°C)
SecurityWPA, WPA2, 802.1X, AES, TKIP
Power SupplyAC Power Supply
Wireless LAN StandardIEEE 802.11a/b/g/n
Form FactorRack-mountable
RedundancyYes
Operating Humidity10% to 90% non-condensing

Related product manuals