12-13
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 12 Configuring Mobility GroupsWireless Device Access
Configuring Mobility Groups
Figure 12-10 Mobility Group Members > Edit All Page
Follow these steps to add more controllers to the mobility group:
a. Click inside the edit box to start a new line.
b. Enter the MAC address, the management interface IP address, and the name of the mobility group
for the controller to be added.
Note These values should be entered on one line and separated by one or two spaces.
Note The mobility group name is case sensitive.
c. Repeat Step a and Step b for each additional controller that you want to add to the mobility group.
d. Highlight and copy the complete list of entries in the edit box.
e. Click Apply to commit your changes. The new controllers are added to the list of mobility group
members on the Static Mobility Group Members page.
f. Click Save Configuration to save your changes.
g. Paste the list into the edit box on the Mobility Group Members > Edit All page of all the other
controllers in the mobility group and click Apply and Save Configuration.
Step 5 Click Multicast Messaging to open the Mobility Multicast Messaging page (see Figure 12-11).
Figure 12-11 Mobility Multicast Messaging Page
The names of all the currently configured mobility groups appear in the middle of the page.
To Next Page
Loading...
Need help?
General
