Cisco 4400 Series User Manual

12-22
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 12 Configuring Mobility GroupsWireless Device Access
Configuring Auto-Anchor Mobility
Figure 12-14 Mobility Anchor Config Page
b.
In the Keep Alive Count field, enter the number of times a ping request is sent to an anchor controller
before the anchor is considered to be unreachable. The valid range is 3 to 20, and the default value
is 3.
c. In the Keep Alive Interval field, enter the amount of time (in seconds) between each ping request
sent to an anchor controller. The valid range is 1 to 30 seconds, and the default value is 10 seconds.
d. Click Apply to commit your changes.
Step 2 Click WLANs to open the WLANs page (see Figure 12-15).
Figure 12-15 WLANs Page
Step 3
Click the blue drop-down arrow for the desired WLAN or wired guest LAN and choose Mobility
Anchors. The Mobility Anchors page appears (see Figure 12-16).
Figure 12-16 Mobility Anchors Page

Cisco 4400 Series Specifications

General

Product Type	Wireless LAN Controller
Manageable	Yes
Management Port	Yes
Power over Ethernet (PoE)	No
Operating Temperature	32 to 104°F (0 to 40°C)
Security	WPA, WPA2, 802.1X, AES, TKIP
Power Supply	AC Power Supply
Wireless LAN Standard	IEEE 802.11a/b/g/n
Form Factor	Rack-mountable
Redundancy	Yes
Operating Humidity	10% to 90% non-condensing