Send document comments to nexus7k-docfeedback@cisco.com
3-24
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03
Chapter 3 Configuring Layer 2 Interfaces
Additional References
switch(config-if)# switchport trunk native vlan 10
switch(config-if)# switchport trunk allowed vlan 5, 10
switch(config-if)# exit
switch(config)# vlan dot1q tag native
switch(config)#
Additional References
For additional information related to implementing access and trunk port modes, see the following
sections:
• Related Documents, page 3-24
• Standards, page 3-24
• MIBs, page 3-25
Related Documents
Standards
Related Topic Document Title
Configuring Layer 3 interfaces Chapter 4, “Configuring Layer 3 Interfaces,”
Port channels Chapter 6, “Configuring Port Channels,”
VLANs, private VLANs, and STP Cisco Nexus 7000 Series NX-OS Layer 2 Switching Configuration
Guide, Release 5.x
Command reference Cisco Nexus 7000 Series NX-OS Interfaces Command Reference,
Release 5.x
Interfaces Cisco DCNM Interfaces Configuration Guide, Release 5.x
System management Cisco Nexus 7000 Series NX-OS System Management Configuration
Guide, Release 5.x
High availability Cisco Nexus 7000 Series NX-OS High Availability and Redundancy
Guide, Release 5.x
VDCs Cisco Nexus 7000 Series NX-OS Virtual Device Context
Configuration Guide, Release 5.x
Licensing Cisco NX-OS Licensing Guide
Release Notes Cisco Nexus 7000 Series NX-OS Release Notes, Release 5.x
Standards Title
No new or modified standards are supported by this
feature, and support for existing standards has not been
modified by this feature.
—