Send document comments to nexus7k-docfeedback@cisco.com
2-54
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03
Chapter 2 Configuring Basic Interface Parameters
Verifying the Basic Interface Parameters
Verifying the Basic Interface Parameters
You can verify the basic interface parameters by displaying their values. You can also clear the counters
listed when you display the parameter values.
Note The system displays only those ports that are allocated to the VDC that you are working in.
DETAILED STEPS
To display basic interface configuration information, perform one of the following tasks:
For detailed information about the fields in the output from these commands, see the Cisco Nexus 7000
Series NX-OS Interfaces Command Reference, Release 5.x.
Monitoring the Interface Counters
You can display and clear interface counters using Cisco NX-OS. This section discusses the following
topics:
• Displaying Interface Statistics, page 2-54
• Clearing Interface Counters, page 2-56
Displaying Interface Statistics
You can set up to three sampling intervals for statistics collections on interfaces.
Command Purpose
show cdp Displays the CDP status.
show interface interface Displays the configured states of one or all
interfaces.
show interface interface Displays the configured states of one or all
interfaces.
show interface brief Displays a table of interface states.
show interface switchport Displays the status of Layer 2 ports.
show interface status err-disabled Displays information about error-disabled
interfaces.
show vdc Displays the status of the existing VDCs.
show udld interface Displays the UDLD status for the current
interface or all interfaces.
show udld-global Displays the UDLD status for the current device.
show port-profile Displays information about the port profiles.
show system internal pktmgr internal ethernet
slot/port
Displays the inbound and outbound rate limit
configuration for packets that reach the supervisor
module on a specific interface.