Send document comments to nexus7k-docfeedback@cisco.com
2-22
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03
Chapter 2 Configuring Basic Interface Parameters
Configuring the Basic Interface Parameters
This example shows how to configure the shared mode for Ethernet port 4/17 in the group that includes
ports 4/17, 4/19, 4/21, and 4/23:
switch# configure terminal
switch(config)# interface ethernet 4/17
switch(config-if)# shutdown
switch(config)# interface ethernet 4/17, ethernet 4/19, ethernet 4/21, ethernet 4/23
switch(config-if)# rate-mode shared
switch(config-if)# no shutdown
switch(config-if)#
Configuring the Error-Disabled State
You can view the reason an interface moves to the error-disabled state and configure automatic recovery.
This section includes the following topics:
• Enabling the Error Disable Detection, page 2-22
• Enabling the Error-Disabled Recovery, page 2-23
• Configuring the Error-Disabled Recovery Interval, page 2-24
Enabling the Error Disable Detection
You can enable error-disable detection in an application. As a result, when a cause is detected on an
interface, the interface is placed in an error-disabled state, which is an operational state that is similar to
the link-down state.
SUMMARY STEPS
1. configure terminal
2. errdisable detect cause {acl-exception | all | link-flap | loopback}
3. shutdown
4. no shutdown
5. show interface status err-disabled
6. copy running-config startup-config
Step 8
exit
Example:
switch(config-if)# exit
switch(config)#
Exits the interface mode.
Step 9
copy running-config startup-config
Example:
switch(config)# copy running-config startup-config
(Optional) Copies the running
configuration to the startup configuration.
Command Purpose
To Next Page
Loading...
