Send document comments to nexus7k-docfeedback@cisco.com
7-57
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03
Chapter 7 Configuring vPCs
Monitoring vPCs
For detailed information about the fields in the output from these commands, see the Cisco Nexus 7000
Series NX-OS Interfaces Command Reference, Release 5.x.
Monitoring vPCs
Use the show vpc statistics command to display vPC statistics.
Note This command displays the vPC statistics only for the vPC peer device that you are working on.
Configuration Examples for vPCs
The following example shows how to configure vPC on device A as shown in Figure 7-11:
Figure 7-11 vPC Configuration Example
Step 1 Enable vPC and LACP.
switch# configure terminal
show vpc peer-keepalive Displays information on the peer-keepalive
messages.
show vpc role Displays the peer status, the role of the local
device, the vPC system MAC address and system
priority, and the MAC address and priority for the
local vPC device.
Command Purpose
vPC peer
link
193286
Nexus 7000
device A
Nexus 7000
device B
vPC
device
vPC
device
7/2 port channel 20
7/1 port channel 20
vPC domain 1
Peer-keepalive
link
7/7 port channel
5O
7/9 port channel
50
port channel
50
port channel
50
To Next Page
Loading...
Need help?
General
