Cisco 7206 - VXR Router

Send document comments to nexus7k-docfeedback@cisco.com
6-43
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03
Chapter 6 Configuring Port Channels
Monitoring the Port-Channel Interface Configuration
Monitoring the Port-Channel Interface Configuration
Use the following commands to display port-channel interface configuration information.
See the Cisco Nexus 7000 Series NX-OS Interfaces Command Reference, Release 5.x, for information on
these commands.
Example Configurations for Port Channels
The following example shows how to create an LACP port channel and add two Layer 2 interfaces to
that port channel:
switch# configure terminal
switch (config)# feature lacp
switch (config)# interface port-channel 5
switch (config-if)# interface ethernet 1/4
switch(config-if)# switchport
switch(config-if)# channel-group 5 mode active
switch(config-if)# lacp port priority 40000
switch(config-if)# interface ethernet 1/7
switch(config-if)# switchport
switch(config-if)# channel-group 5 mode
The following example shows how to add two Layer 3 interfaces to a channel group. The Cisco NX-OS
software automatically creates the port channel:
switch# configure terminal
switch (config)# interface ethernet 1/5
switch(config-if)# no switchport
switch(config-if)# no ip address
switch(config-if)# channel-group 6 mode active
switch (config)# interface ethernet 2/5
switch(config-if)# no switchport
switch(config-if)# no ip address
Command Purpose
clear counters interface port-channel
channel-number
Clears the counters.
clear lacp counters [interface port-channel
channel-number]
Clears the LACP counters.
load- interval {interval seconds {1 | 2 | 3}} Beginning with Cisco NX-OS Release 4.2(1) for
the Cisco Nexus 7000 Series devices, sets three
different sampling intervals to bit-rate and
packet-rate statistics.
show interface counters [module module] Displays input and output octets unicast packets,
multicast packets, and broadcast packets.
show interface counters detailed [all] Displays input packets, bytes, and multicast and
output packets and bytes.
show interface counters errors [module
module]
Displays information on the number of error
packets.
show lacp counters Displays statistics for LACP.