Cisco 7206 - VXR Router User Manual

Send document comments to nexus7k-docfeedback@cisco.com
6-39
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03
Chapter 6 Configuring Port Channels
Configuring Port Channels
This example shows how to enable LACP graceful convergence on a port-channel:
switch# configure terminal
switch (config)# interface port-channel 1
switch(config-if)# shutdown
switch(config-if)# lacp graceful-convergence
switch(config-if)# no shutdown
Disabling LACP Suspend Individual
LACP sets a port to the suspended state if it does not receive an LACP PDU from the peer. This can cause
some servers to fail to boot up as they require LACP to logically bring-up the port. You can tune behavior
to individual use.
Note You should only enter the lacp suspend-individual command on edge ports. The port channel has to be
in the administratively down state before you can use this command.
BEFORE YOU BEGIN
Enable LACP.
Ensure that you are in the correct VDC (or use the switchto vdc command).
SUMMARY STEPS
1. configure terminal
2. interface port-channel number
3. shutdown
4. no lacp suspend-individual
5. no shutdown
6. copy running-config startup-config
DETAILED STEPS
Command Purpose
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Enters configuration mode.
Step 2
interface port-channel number
Example:
switch(config)# interface port-channel 1
switch(config-if)
Specifies the port channel interface to configure, and
enters the interface configuration mode.
Step 3
shutdown
Example:
switch(config-if) shutdown
Administratively shuts down the port channel.

Cisco 7206 - VXR Router Specifications

General

Brand	Cisco
Model	7206 - VXR Router
Category	Network Router
Language	English